Possible causes

– Faulty Intake Air Temperature (IAT) sensor
– Dirty air filter
– Intake Air Temperature (IAT) sensor harness is open or shorted
– Intake Air Temperature (IAT) sensor circuit poor electrical connection

When is the code detected?

When the PCM senses a signal voltage lower than the normal operating range of the sensor, this DTC sets.

Symptoms

– Engine Light ON (or Service Engine Soon Warning Light)

P0112 CHEVROLET Description

The Intake Air Temperature (IAT) sensor contains a semiconductor device which changes the resistance based on the temperature (a thermistor). The IAT sensor is located in the air intake passage of the engine air induction system. The IAT sensor has a signal circuit and a ground circuit. The Powertrain Control Module (PCM) applies 5.0 volts on the signal circuit to the sensor. The PCM monitors the changes in this voltage caused by changes in the resistance of the sensor in order to determine intake air temperature.
When the intake air is cold, the sensor (thermistor) resistance is high. The PCMs signal voltage is only pulled down a small amount through the sensor to a ground; therefore, the PCM senses a high signal voltage (low temperature). When the intake air is warm, the sensor resistance is low. The signal voltage is pulled down a greater amount; therefore, the PCM senses a low signal voltage (high temperature).

CHEVROLET Technical Service Bulletins for P0112 code